Virtual access GW1000 Manual do Utilizador

2/4 port VoIP Gateway User Manual

support the WAN interface for Internet access and remote access. The following sections will explain more details of WAN Port Internet access and broa

User Name: Enter User Name provided by your ISP Password: Enter Password provided by your ISP. Retype Password: Enter Password to confirm again.

Bridge Mode: Select S series Gateway as bridge. NAT mode: LAN IP Network Configuration IP Address: Private IP address for connecting to a local

common Line Hunting Group Number. When this number is dialed, the Gateway system will find a free FXO line connected to PBX. This hunting will skip al

z In the “Outgoing Dial Plan” settings:  “Leading Number” is the leading digits of the dialing number.  “Min Length” and “Max Length” is the

4.1 Network Configuration: 4.1.1 WAN Port Type Setup For most users, Internet access is the primary application. The S400/S200 Series Gateway suppo

PPPoE for ADSL Some ISPs provide DSL-based service and use PPPoE to establish communication link with end-users. If you are connected to the Intern

DHCP Client (Dynamic IP): (Get WAN IP Address automatically) IP Address: If you are connected to the Internet through a Cable modem line then a dyn

LAN IP Network Configuration IP Address: Private IP address for connecting to a local private network (Default: 10.10.10.1). Subnet Mask: Netmask for

Public Port: Specifies which port should be redirected to the internal host. Private IP: Specifies the private IP address of the internal host off

Table of Contents 0. Preface 0.1 About This Manual 0.2 Copyright Declarations 0.3 Trademarks 0.4 Safety Instructions 0.5 Warranty 1. Getting

CID Number: The CID number is the phone caller ID number. 4.4.4 Let GW Register to H.323 Gatekeeper (If user does not have Gatekeeper, Please go t

4.4.4 Dialing Plan Overview of the Dialing Plan The “Dialing plan” need setting when the user use the method of pear-to-pear VoIP call. The VoIP ca

z In the “Incoming Dial Plan Configurations” settings:  “Inbound number” is the leading digits of the dialing number.  “Length of Number“ has

H.323 Start Mode: This selection could force the Gateway to use normal start mode (default mode) or fast start mode when establishing a VoIP call. Man

Port Status Display : This selection will display concurrent call status of this Gateway. The status information of each voice channel includes co

5.2 Access Control Changing the Administrator Password For security reasons, we strongly recommend that you set an administrator password for the rou

5.4 Backup/Restore Configuration to a File User can Backup the Configuration to a File at Microsoft Operation System. And also restore the configurat

Click SNTP Setting to open the Online Status page. In the example, on the following page, . Use SNTP Setting—When checked, Gateway uses a Simple N

network usage. 6. What is the maximum number of IP addresses that the DHCP server of the gateway can assign to local PCs? A: The built-in DHCP serve

Scenario 2 : H.323 VoIP Call: Peer-To-Peer Mode Gateway 1 (with PBX) <----> Gateway 2 Gateway#1 Gateway#2 801901Outg

0 Prefaces 0.1 About This Manual This manual is designed to assist users in using VoIP Gateway. Information in this document has been carefully check

Scenario 3 : H.323 VoIP Call : Peer-To-Peer Mode Gateway 1 (with PBX/PSTN)<----> Gateway 2 Call Method : Two-Stages-Dial

Scenario 4 : H.323 VoIP Call : Peer-To-Peer Mode Gateway 1 (with PBX/PSTN) <----> Gateway 2 Call Method: One-Shot-Diali

Scenario 5: H.323 VoIP Call: Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (Remote Call PSTN number) Call Method: One-Sh

Scenario 6 : H.323 VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (PSTN Call PSTN number) Call Method : One-S

Scenario 7: H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 Gateway#1Gateway#2 Outgoing Dial pla

Scenario 8 : H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 (Call PBX extension number) Call Method : Tw

Scenario 9 : H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 (Remote Call PSTN number with PBX) Call Met

Scenario 10 : H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 (Remote Call PSTN number with PBX) Call

Scenario 11 : H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 (Remote Call PSTN number) Call Method :

Scenario 12 : H.323 VoIP Call : Register to Gatekeeper Gateway 2 <----> Gateway 1 (PSTN Call PSTN number) Call Method : On

1 Getting Started 1.1 Introduction This VoIP Gateway provides a total solution for integrating voice-data network and PSTN. By simple installation, T

Scenario 13 :SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 Gateway#1Gateway#2 Incoming Dial Plan No:

Scenario 14 : SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (call PBX extension number) Call Method : Two

Scenario 15 : SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (Remote Call PSTN number with PBX) Call Metho

Scenario 16 : SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (Remote Call PSTN number with PBX) Call Meth

Scenario 17 : SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (Remote Call PSTN number) Call Method : One-

Scenario 18 : SIP VoIP Call : Peer-To-Peer Mode Gateway 2 <----> Gateway 1 (PSTN Call PSTN number) Call Method : One-Sh

Scenario 19 : SIP VoIP Call : Register to SIP Proxy Server Gateway 2 <----> Gateway 1 Gateway#1Gateway#2 Outgoing Di

Scenario 20 : SIP VoIP Call : Register to SIP Proxy Server Gateway 2 <----> Gateway 1 (Call PBX Extension number) Call Method

Scenario 21 : SIP VoIP Call : Register to SIP Proxy Server Gateway 2 <----> Gateway 1 (Remote Call PSTN number with PBX) Cal

Scenario 22 : SIP VoIP Call : Register to SIP Proxy Server Gateway 2 <----> Gateway 1 (Remote Call PSTN number) Call Meth

NOTE: System initialization will turn some LEDs ON for a few sec. 1.2.2 Rear Panel Descriptions 1. WAN The WAN port supports 10/100Base-T networks

Scenario 23 : SIP VoIP Call : Register to SIP Proxy Server Gateway 2 <----> Gateway 1 (PSTN Call PSTN number) Call Method

Gateway#1 Gateway#2 801 WANSIP Call (SIP Proxy Server Mode) : PSTN Call PSTN number Method: Two-Stages-Dialing 901 P

Ring. 5. Call Passthrough NAT: This feature allows GW to operate behind NAT-enabled devices and user does not need modify any configuration of NAT dev

address. For a fixed IP address, use an IP address from a 192.168.1.0/24 network, such as 192.168.1.10. For a dynamic IP address, you need to set the

3. If this is a first time setup of the router, type “admin” as the User Name and the Password field as “admin”. Click OK. 4. The Web Configurator Se

or ”PPPoE”.Usually the router functions as a border router for SOHO or home networking so you must enter your settings here to enable access to the In